|
|
UK 0844 8004258
Mon-Fri 9AM-5PM
|
|
|
|
| Disclaimer:Any
information provided on this website is for general guidance
only. It does not constitute any contractual term, representation
or warranty. As such, spark-plugs.co.uk takes no responsibility
in respect of any claim whatsoever and howsoever caused arising
from use of any information on this website. Prices may be subject
to change without warning. The presence of a part in our price
lists does not necessarily guarantee availability. |
|
| |
|
|
If
you require further help or cross-reference information, please
consult the technical section and FAQ's before contacting
us Do not risk fitting the
wrong part!
|
|
|
Glow
plug FAQ's
|
|
1. Can you supply part
number Champion AG4 for my BMC 2.2 diesel taxi or marinised engine?
2. Can you supply a ceramic glow plug to replace my
standard metal sheathed glow plug?
3. My main dealer wants to charge me £xx for
a single glow plug, can you supply a cheaper equivalent?
4. I have a Japanese import diesel vehicle, can you
recommend a suitable replacement plug?
5. I can't find my part number listed on your website,
can you supply it?
6. Can you supply an Auburn ignitor rod for use in
my incinerator/furnace/oven etc?
7. Can you supply Bosch glow plugs?
8. How long should my glow plugs last?
|
|
|
1. Can
you supply part number Champion AG4 for my BMC 2.2 diesel taxi or
marinised engine?
No, unfortunately this part has been obsolete for some time
with no replacement and no possibility of Champion reproducing it.
We are able to supply a Beru part which is similar but we cannot
guarantee suitability.
|
|
2. Can
you supply a ceramic glow plug to replace my standard metal sheathed
glow plug?
No, all glow plug recommendations are matched to the engine, electrical
system and operating conditions, as such we would not be able to
recommend a ceramic alternative to the NGK or Champion recommended
part.
|
|
3. My
main dealer wants to charge me £xx for a single glow plug,
can you supply a cheaper equivalent?
If you can supply us with the part number we may be able to replace
or cross reference to a part which you could use as a replacement.
Some OEM (orignal) plugs are only available through main dealers
and are not available through aftermarket channels. If we can supply
a replacement or equivalent part it will usually be considerably
cheaper than the main dealer price.
|
|
4. I
have a Japanese import diesel vehicle, can you recommend a suitable
replacement plug?
This can be tricky, there are usually a number of engine variations
requiring different parts. We may need extensive details from you
in order to identify the correct part. By far the easiest is to
check what plugs are installed and replace with the same part number
if available (assuming the plugs were functioning correctly up until
failure).
|
|
5. I
can't find my part number listed on your website, can you supply
it?
Please mail details of the part you are looking for, it may be a
USA only part or a very new part which is not yet listed. We will
check and reply.
|
|
6. Can
you supply an Auburn ignitor rod for use in my incinerator/furnace/oven
etc?
Please supply part numbers, we have no application guides for any
products requiring ignitor rods but we may be able to source from
a specialist supplier. Unfortunately they are usually only available
in box quantity and are often expensive.
|
|
7. Can
you supply Bosch glow plugs?
No, sorry, unless required in very large quantities (200+) when
we may be able to place a special order.
|
|
8. How
long should my glow plugs last?
This is highly subjective, providing all the engine's systems are
working correctly then they should last a long time. A fault with
a relay can cause a plug to fail almost instantly. If the vehicle
is used for short journeys and the engine is stopped and started
often then plug life may be shortened - the heating coil is only
used at engine startup and it is this which is most likely to fail.
|